Sub Assembly - Frame
The frame of the scope is made from 2020 (20x20mm) and 2040 (20x40mm) aluminium extrusions. The frame is secured using right angle brackets with M4x6mm screws and T-nuts.
| Sr No. | Part | Qty |
|---|---|---|
| 1 | Right Angle Bracket | 16 |
| 2 | M4x6mm Socket Head Screw | 64 |
| 3 | M4 T-nut | 64 |
The alumnum extrusion is cut to the following lengths:
2020 Extrusion
| Sr No. | Length | Qty |
|---|---|---|
| 1 | 350mm | 2 |
| 2 | 175mm | 2 |
| 3 | 205mm | 2 |
| 4 | 215mm | 2 |
| 5 | 300mm | 3 |
2040 Extrusion
| Sr No. | Length | Qty |
|---|---|---|
| 1 | 300mm | 1 |
The frame is assembled as follows:
- Assemble the 2020 extrusions as shown in the image below. Hover over the table on the left to the see location of the profiles in the image on the right and vicevera.
- Fasten the bottom panel to the frame using M4x8mm screws (the length is depends on the your laser cut thickness) and T-nuts. Make sure the panel is flush with the back of the frame.